I also think it's the most logical

the measure of B is 305mm (30.5cm)

Hi,
I covered the cushion with a beautiful red leather skaï
(leather skaï = skin of a plastic cow, of course)

to have a thin skin, I pulled back the tissue.

the result

here is the false engine.
no 3D printer or computer
only plastic pipe, wood, glue ...

Not bad Mark If you like, I can print one for you

Hey Marc!

Your motor looks great. Much more personality than all of the 3d printers. What an inspiration for me.

And also the whole boat is fantastic. A real eye-catcher.
The shape reminds me of Walt Disney's adaptation of Jules Vernes "20,000 Leagues Under the Sea". So would name the boat Nautilus.

Great job
Jenjen

Looks good, great motor for the boat!

Marc,
the more i followed your build the more my fingers tickled and since my building board is vacant again:
Would you mind sharing the plans with me? I'm considering building the one depicted in #67 . The hull should be identical with the one difference of the front being convex rather than two concaves forming a sharp edge.

Lex,
in post #69 you mentioned a mail with additional information(?) about the Marc's boat. Could you share that info, too, please?
Thanks
Martin

Martin,

you have a mail

Marc,
thank! I'll wait till the plan is available.
Martin

mbultmann schrieb:
normally september 2021.